Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
ES Windows Sliding & Patio Doors in Boca Raton: What to Know First
ES Windows sliding and patio doors in Boca Raton can be serviced and repaired by our team, and most jobs are handled in a single visit. As an independent ES Windows service provider, we’re not affiliated with the manufacturer, which means we can call the issue as it actually is rather than how a factory script says it should sound. Repair work typically runs $250 to $900 depending on the rollers, track, and hardware involved, and full door replacement runs higher. If you own an ES Windows sliding door that’s binding, leaking, or off its track, call (561) 264-1337 and we’ll walk through what you’re seeing.
How ES Windows Products Fail - and How We Fix Them
- Roller degradation on the ES7900 and ES7800 series. The factory rollers on these lines are nylon-wrapped and they flat-spot after years of Boca Raton humidity and daily use. You’ll feel a door that rolls rough for the first foot, then smooths out. We replace the roller assemblies with sealed stainless-steel bearings that don’t depend on factory stock, and the door moves like it did the day it was hung.
- Track wear on multi-panel ES panoramic systems. These systems carry a lot of glass, and when the track gets sand and shell grit worked into it by bare feet and beach air, the panels start to drag. We see this constantly in Boca Raton. We clean the full track channel, check for grooving, and either dress the track or install a new section rather than letting the panels wear themselves into a bigger problem.
- Weatherstripping compression at the interlock post. ES doors seal where the panels meet, and after enough hurricane seasons that interlock weatherstripping compresses and the door starts to whistle during afternoon storms. We replace it with a marine-grade pile and fin seal, which is a material the factory doesn’t always ship from the distributor, and it’s an hour of work rather than a new door.
- Threshold and sill separation on older ES installations. When the original installer set the sill on a bed of caulk instead of a proper shim line, the threshold works loose and you get water sneaking under the door in a driving rain. We pull the sill, set it on a continuous shim line, and bed it in sealant so the water goes out instead of under.
- Lock and latch misalignment after settlement. Boca Raton sits on sand and limestone, and houses shift. The factory two-point lock on an ES sliding door has very little tolerance for a frame that has moved even an eighth of an inch. We realign the keepers and, when needed, replace the latch mechanism with an aftermarket piece that has a wider engagement range than the original.
Our ES Windows Sliding & Patio Doors Process
- 1
The call. You reach a live person at (561) 264-1337, day or night. We ask what the door is doing, which line it is if you know it, and when it started. No callback form, no voicemail tree.
- 2
The measure. A background-checked, uniformed technician arrives on time and measures the opening twice. We inspect the rollers, track, interlock, sill, and frame corners for square. Dale Kessler’s founding rule is on the whiteboard in the shop: if the pane is not true, the job is not done.
- 3
The parts decision. We quote OEM and quality aftermarket parts side by side on paper, with the exact supplier and the exact price. If your ES Windows door is under warranty and the warranty applies, we’ll tell you and help you work through it. If it isn’t, you get the choice in writing before anything is ordered.
- 4
The work. For most roller, track, weatherstripping, and latch jobs, we carry the common parts on the truck and the job is done in one visit. Heavy glass panels stay right where they are unless the job truly requires lifting them out.
- 5
The test. We roll the door open and closed a dozen times, hose the exterior, and check for daylight anywhere along the seal. The door doesn’t leave the truck’s shadow until it behaves the way it should.
- 6
The paperwork. You get both warranty layers completed in writing before we leave. The Done Right Promise means if it isn’t right, we make it right with no arguing and no fine print. The Keystone Standard governs every job, including this one.
What ES Windows Sliding & Patio Doors Costs in Boca Raton
Here are real ranges for the ES Windows scenarios we see most often in Boca Raton:
- Roller replacement (both panels): $250 to $450 depending on the line and panel weight.
- Track cleaning, dressing, or replacement: $150 to $500 depending on length and damage.
- Interlock weatherstripping replacement: $100 to $250.
- Latch, lock, and keeper realignment: $100 to $300.
- Threshold reset and reseal: $300 to $700 depending on width and water damage.
- Full sliding door replacement: $1,800 to $6,000 and up, driven by panel count, glass type, and trim work.
What moves the price is panel count, the condition of the track, and whether the frame has moved out of square. We never quote over the phone blind, but we do give you a fixed number on paper before work starts. No surprise line items on the bill, no change orders after the fact. Call (561) 264-1337 for a free estimate and a written quote.
Why Boca Raton Homeowners Call TruePane Windows & Doors for ES Windows Work
We’re a local shop, founded by Dale Kessler in 2008, and the company carries years of community service through a heritage that goes back to his father replacing jalousie windows in Boca Teeca every weekend. That kind of history means something when a manufacturer has moved its support line overseas and you’re standing in front of a door that won’t close before a storm. Our technicians know ES Windows lines and the symptoms they develop in this climate, and when a door is too far gone, we quote replacements from Andersen, Pella, and PGT side by side on paper so you know exactly what you’re buying. Every job is covered by the Done Right Promise and The Keystone Standard. We stand behind it, in writing, and a live person answers the phone any hour you call.
FAQs
Most ES Windows sliding door warranties are pro-rated after ten years, which means coverage for parts and labor has been reduced or, in many cases, ended. What many Boca Raton homeowners discover is that the warranty covers the hardware but not the labor to fit it, and the factory parts can take weeks to arrive. We help you determine what your specific warranty covers before any work is done. Call (561) 264-1337 and we’ll walk through it with you.
Yes, but not always from the manufacturer’s distribution channel. For common wear items like rollers, weatherstripping, and latches, we carry or can source quality aftermarket equivalents that are sealed and rated for this climate, often faster than factory-stock parts can be shipped. If you want the OEM part specifically, we’ll quote it with the real lead time and let you decide. Estimates are free.
Repair almost always wins when the frame is square, the glass is intact, and the issue is confined to rollers, track, weatherstripping, or hardware. Replace when the frame has separated, the glass is fogged, or water intrusion has rotted the surrounding framing. We’ll tell you which side of the line you’re on without pushing you toward the more expensive option. Call (561) 264-1337 for an honest read.
In most cases in Boca Raton, we can get a technician to you the same day or next day for an off-track door, because a door that’s off its track is a safety and security problem, not a cosmetic one. A live person answers the phone 24/7, so you’ll get a real answer when you call. Call (561) 264-1337 and tell us what the door is doing.
When a permit is required, yes, we pull it and the inspection gets passed before we call the job done. A door replacement that changes the opening or is part of a structural wall falls under Boca Raton building code, and we don’t skip it. That’s part of a square deal: the work is done to code, the warranty holds, and the city signs off. Call (561) 264-1337 for a free estimate on your project.
If you own ES Windows sliding or patio doors in Boca Raton and they’re not rolling, locking, or sealing the way they should, call TruePane Windows & Doors at (561) 264-1337. We’ll send a uniformed, background-checked technician to measure it properly, quote the work on paper, and stand behind the result. Free estimates. Done right the first time. And if it isn’t square and it isn’t sealed, it isn’t done.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Boca Raton and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After