PGT Sliding Glass & Patio Doors Nationwide | TruePane Windows & Doors

PGT Sliding Glass & Patio Doors in Boca Raton: What to Know First

PGT sliding glass and patio doors in Boca Raton usually cost $380-$2,400 to repair, depending on whether we’re replacing rollers, rebuilding a track, or swapping the entire panel. Most sliding door repairs take one visit, with the truck in the driveway for two to four hours. We’re an independent PGT service provider, which means we work for you, not the factory. If your PGT door drags, sticks, fogs, or won’t lock, call (561) 264-1337 and we’ll tell you what you’re looking at before we ever schedule the appointment.

Call (561) 264-1337

This page is written for PGT owners in Boca Raton who’ve lived with their doors long enough to know when something’s off. You want straight answers on cost, parts, and whether a repair makes sense or if it’s time to replace. That’s what we do.

How PGT Products Fail, and How We Fix Them

PGT builds a solid door. But every sliding door in South Florida works hard, and after ten or fifteen years of salt air, sun, and daily use, specific things go wrong. Here’s what we see most often on PGT lines like the 500/700 Series and WinGuard sliding doors in Boca Raton:

• Dragging or binding panels on 700 Series and WinGuard sliders. The aluminum track fills with sand and shell grit from beachside air, the rollers flatten or seize, and the door starts chewing itself up. We pull the panel, clean the track bed, replace rollers with OEM or equal-quality aftermarket sets rated for the panel weight, and reset the reveal. A door that slides with two fingers when we leave is the standard.
• Fogged glass or condensation between panes. On insulated PGT units, the argon fill leaks out when the edge seal fails, usually from years of thermal cycling. The glass looks streaky and you can’t wipe it off. We order a replacement insulated glass unit matched to the original frame dimensions and glazing spec, then reseal and reglaze. The frame stays; the view comes back.
• Locking hardware that fights you. The multi-point lock bodies and keepers on older PGT 500 Series doors wear out of alignment. Forcing the handle strips the internal gears and then the door won’t secure at all. We realign, replace worn hardware with PGT-compatible parts, and test the full throw of the lock before we call it done.
• Water staining at the bottom corners of WinGuard impact doors. The weep holes designed to drain the track get clogged with pollen and fine sand. Water backs up, wicks into the frame, and stains the interior dead corner. We clear the weep system, check the sill dam, and reseal where the frame meets the slab so drainage works the way the engineers intended.
• Roller assemblies that have never been serviced. On PGT doors installed during the Boca building boom of the early 2000s, original rollers are often past their useful life. Homeowners assume the door needs replacing. It doesn’t. New rollers, new track caps, and a proper adjustment usually give the door another decade.

Our PGT Sliding Glass & Patio Doors Process

We run a PGT sliding door job the same way we run every job: measure twice, write it down, and leave the house cleaner than we found it. Here’s how it goes.

1. 1
   Call and diagnosis. You call (561) 264-1337, a live person answers, and we ask about your PGT door: model if you know it, symptoms, how long it’s been acting up. We schedule a time and show up on it.
2. 2
   On-site inspection. Our tech measures the opening, checks the track, rollers, glass, and hardware. We write up the findings and quote you the fix on paper before any work starts.
3. 3
   Parts decision. We tell you the difference between OEM PGT parts and quality aftermarket equivalents, including price. The choice is yours, in writing. No surprises later.
4. 4
   The repair. We do the work in one visit whenever possible, whether that’s a roller replacement, glass swap, track rebuild, or new hardware set.
5. 5
   Operation test. We cycle the door a dozen times, check the lock throw, check the weep drainage, and make sure the panel sits square in the frame. If it isn’t square and it isn’t sealed, it isn’t done.
6. 6
   Warranty registration and cleanup. We register the work through The Keystone Standard and sweep the debris. You have our number if anything needs attention.

What PGT Sliding Glass & Patio Doors Costs in Boca Raton

What moves the price most is glass type. Impact-rated WinGuard units carry a meaningfully higher materials cost than standard insulated glass. Parts source matters too: OEM PGT components cost more than quality aftermarket, and we quote both so you can see the difference on paper. We charge by the job, not the hour, and the number we quote is the number you pay. Call (561) 264-1337 for a free estimate on your specific door.

Why Boca Raton Homeowners Call TruePane Windows & Doors for PGT Work

We’ve been putting windows and doors in South Florida homes since 2008. Dale Kessler, our owner, grew up in the Boca Teeca neighborhood of Boca Raton watching his father replace jalousie windows on Saturdays, and that standard stuck. On a PGT door, we register both manufacturer warranty layers in writing before the truck leaves your driveway, and every job carries our Done Right Promise. If something isn’t right, we come back and make it right. No paperwork fights, no fine print.

Plenty of our customers own PGT. Some own CGI, CWS, ES Windows, or ECO Window Systems. We service them all, so if your home has mixed brands across different openings, one call covers it. Our techs are background-checked, uniformed, and trained to treat your home the way they’d treat their own mother’s. Call (561) 264-1337 and talk to a person who knows doors.

FAQs